Tint Wallet guide

Why sending USDT on Tron costs TRX, and how fees work on other networks

Every network charges its fee in its own coin, not in the token you send. Why a USDT transfer on Tron needs TRX, what fees look like on Ethereum-family networks, Solana, Bitcoin and Monero, and how Tint Wallet shows them.

Checked against the app on

The rule: the fee is paid in the network's own coin

A token such as USDT or USDC lives on a network that has its own coin, and the network takes its fee in that coin: TRX on Tron, ETH on Ethereum, SOL on Solana. So with 100 USDT and no TRX on Tron you cannot send any of the USDT.

Tron: why USDT needs TRX

A USDT transfer on Tron runs the token's contract and uses two network resources, energy and bandwidth. An account that has not staked TRX for them pays by burning TRX, and that burned TRX is the fee you see.

  • Sending USDT to an address that has never held USDT usually costs more energy, so more TRX, than sending to one that has.
  • Sending TRX to an address that has never been used costs an extra activation fee.
  • Tint Wallet shows the fee in TRX before you confirm. If there is not enough TRX, it says how much is needed.

Have only USDT on Tron? First get a little TRX to the same address: withdraw TRX from an exchange, or turn a coin you hold on another network into TRX with a transfer between networks. Swapping USDT for TRX inside Tron starts with a USDT payment too, so it also needs TRX. More on USDT on Tron in the USDT TRC20 guide.

Fees by network

NetworkFee paid inWhat the fee depends on
TronTRXEnergy and bandwidth; a token transfer uses more than a TRX transfer
Ethereum, Base, Arbitrum, OP Mainnet, ZoraETHGas: how much work the transaction does, times the current gas price
BNB Chain, Polygon, Avalanche, Celo, HyperEVM, X LayerBNB, POL, AVAX, CELO, HYPE, OKBGas, the same way
SolanaSOLA fee per signature; a new token account also holds a deposit
Bitcoin, LitecoinBTC, LTCThe size of the transaction in bytes, not the amount, times the current fee rate
MoneroXMRThe size of the transaction

Ethereum-family networks

Tint Wallet has one address for all 11 Ethereum-family networks, but each network has its own balance and its own fee coin: USDT on BNB Chain needs BNB, USDC on Base needs ETH on Base. On Ethereum itself fees are usually higher than on networks such as Base, Arbitrum or Polygon.

A swap or a transfer between networks often takes two payments here: first an approval for the contract, then the swap itself, and each has a fee. See token approvals.

On Ethereum, Base, Arbitrum, OP Mainnet, Polygon and Avalanche the send screen can also pay the fee in USDC instead of the network coin, if you hold USDC there. It stays off until you turn it on for a payment. The first time, an open contract for paying in USDC is attached to your address; removing it later costs a fee in the network coin.

Solana

Fees are paid in SOL. Every token account also holds a deposit of about 0.002 SOL, and an account must keep a minimum amount of SOL: the wallet says so if a payment would go below it. When a token account is empty, Tint Wallet can close it and return the deposit; what that costs is on the support page.

Bitcoin and Litecoin

The fee depends on the size of the transaction in bytes, not on the amount. A wallet that has received many small payments has to put all of them into one transaction to send a large sum, so the fee grows; if such a payment gets too large, Tint Wallet asks you to send it in two parts. Amounts below the network's minimum cannot be sent at all.

Monero

Fees are paid in XMR and depend on the size of the transaction. Tint Wallet works out the exact fee before you confirm. See the Monero guide.

Network fee and Tint's fee

  • The network fee goes to the network, not to Tint. It is charged on top of the amount and shown before you confirm.
  • A plain send or receive carries no Tint fee. Tint charges a fee on swaps, transfers between networks, meme coin trades and SOL rent returns; it is shown before you confirm and listed on the support page.
  • The services the wallet routes through may add their own costs, which the quote shows.

Questions

Why does the wallet say there is not enough TRX when I have USDT?

Because the Tron fee is paid only in TRX. Get a little TRX to the same Tron address and send again.

How much TRX should I keep?

The wallet shows the fee in TRX before each payment and says how much is missing. Keep somewhat more than one fee, because a transfer to a new recipient can cost more.

Why was my fee different last time?

Fees follow how busy the network is. On Tron they also depend on whether the recipient has held the token before; on Bitcoin and Litecoin, on how many incoming payments the transaction spends.

Where does the network fee go?

To the network: to the validators or miners who record the transaction, or it is burned. Tint's own fee is separate and is listed on the support page.